Remove 4 from default runlevel in xen-watchdog, xend and xendomains.
Similar to what changeset 24847:
0900b1c905f1 does in xencommons, remove
runlevel 4 from the other runlevel scripts. LSB defines runlevel 4 as
reserved for local use, the local sysadmin is responsible for symlink
creation in rc4.d.
Runlevel 4 was specified in Default-Start since a very long time. Then
it was copied also to the new xen-watchdog in 21861:
fb3649141e19. Until
now this was not an issue since only xencommons is automatically enabled
during package install, and a custom xend and xendomains script is
included in the SuSE packages. Since some time a rpmlint check complains
about the wrong Default-Start entry in xen-watchdog.
Signed-off-by: Olaf Hering <olaf@aepfle.de>
Committed-by: Ian Jackson <ian.jackson.citrix.com>
# Should-Start: xend
# Required-Stop: $syslog $remote_fs
# Should-Stop: xend
-# Default-Start: 2 3 4 5
+# Default-Start: 2 3 5
# Default-Stop: 0 1 6
# Short-Description: Start/stop xen-watchdog
# Description: Run domain watchdog daemon.
# Should-Start:
# Required-Stop: $syslog $remote_fs xenstored xenconsoled
# Should-Stop:
-# Default-Start: 2 3 4 5
+# Default-Start: 2 3 5
# Default-Stop: 0 1 6
# Short-Description: Start/stop xend
# Description: Starts and stops the Xen control daemon.
# Should-Start: xend
# Required-Stop: $syslog $remote_fs xenstored xenconsoled
# Should-Stop: xend
-# Default-Start: 2 3 4 5
+# Default-Start: 2 3 5
# Default-Stop: 0 1 6
# Short-Description: Start/stop secondary xen domains
# Description: Start / stop domains automatically when domain 0